Husky H4130 Manuale delle Istruzioni Scaricare il pdf

Operation

Operating the ratchet wrench

□ This 3/8” Ratchet Wrench is designed to operate on

90 PSIG. Lower pressure (below 90 PSIG) will reduce

performance of the tool. Higher air pressure (over 90

PSIG) raises the performance of the tool beyond its rated

capacity and could cause serious damage to the tool and

the user.

Changing the direction of the tool

WARNING: Disconnect the tool from the air supply before

servicing or changing accessories.

□ The direction of the tool is reversible.

□ Control the rotation direction by turning the reverse button

above the ratchet head to R (Reverse) or F (Forward).

Installing and removing the sockets

WARNING: Disconnect the tool from the air supply before

servicing or changing accessories.

To install sockets:

□ Remove the air supply from the ratchet wrench.

□ Fit the 3/8” square drive socket onto the anvil, pushing on

the socket.

To remove sockets:

□ Remove the air supply from the ratchet wrench.

□ Holding the socket rmly, pull it off the anvil.

Driving the nuts and bolts

□ Place the reverse button located above the head of the

ratchet wrench to the correct direction, F (Forward) or R

(Reverse). Fit the correct size socket to the anvil of the

ratchet wrench.

□ Hold the ratchet wrench with one hand and place the

socket onto the nut/bolt to be tightened or removed. Press

the throttle lever and stop the operation once the nut/bolt

is removed or tightened.

6 Operation1 Operating the ratchet wrench □ This 3/8” Ratchet Wrench is designed to operate on 90 PSIG. Lower pressure (below 90 PSIG) will reduce pe

Più documenti per no Husky H4130

Nessun commento