Husky H4110 Manuale delle Istruzioni Scaricare il pdf

Operation

Operating the ratchet wrench

□ This 3/8” Ratchet Wrench is designed to operate on 90

PSIG. Low pressure (below 90 PSIG) will reduce the power

output. Higher pressure (over 90 PSIG) raises the tool

performance beyond its rated capacity and could result in

serious damage to the tool and/or operator.

Changing the output torque direction

□ This tools features the reverse switch to change the

output torque direction to tighten (assemble) or loosen

(disassemble) the bolt or fastener. Control the output torque

direction by turning the reverse switch to the F (Forward)

or R (Reverse) position to change the direction.

Installing and removing the sockets

WARNING: Disconnect the tool from air the supply before

servicing or changing accessories.

To install the sockets:

□ Disconnect the tool from the air source.

□ Select the suitable and desirable socket size.

□ Press t the anvil into the socket.

To remove the impact socket:

□ Disconnect the tool from the air source.

□ Use your hand or suitable tool to remove the socket.

Tightening or loosening the bolt or

fastener

□ Fit the socket in.

□ Hold the ratchet wrench with one hand.

□ Use the tool to tighten or loosen the bolt or fastener.

6 Operation1 Operating the ratchet wrench □ This 3/8” Ratchet Wrench is designed to operate on 90 PSIG. Low pressure (below 90 PSIG) will reduce the

Più documenti per no Husky H4110

Nessun commento