Husky H4470 Manuale di Manutenzione e Cura Scaricare il pdf

7 HUSKYTOOLS.COM

Please contact 1-888-43-HUSKY for further assistance.

Maintenance

Ensure the air line is shut-off and drained of air before removing this tool from service. This will prevent the tool from operating

if the throttle is accidentally engaged.

LUBRICATION

□ An in-line ﬁlter-regulator-lubricator is recommended as it increases tool life and

keeps the tool in sustained operation.

□ Regularly check and ﬁll the in-line lubricator with air tool oil. Avoid using

excessive amounts of oil.

□ Adjust the in-line lubricator by placing a sheet of paper next to the tool’s exhaust

ports and holding the throttle open approximately 30 seconds. The lubricator is

properly set when a light stain of oil collects on the paper.

□ If it is necessary to store the tool for an extended period of time (overnight,

weekend, etc.), generously lubricate the tool through the air inlet. Run the tool for

approximately 30 seconds to ensure the oil is evenly distributed throughout the

tool. Store the tool in a clean and dry environment.

□ Recommended lubricants: Air tool oil or any other high grade turbine oil

containing moisture absorbent, rust inhibitors, metal wetting agents, and an EP

(extreme pressure) additive.

1 2 3

7 HUSKYTOOLS.COM Please contact 1-888-43-HUSKY for further assistance.MaintenanceEnsure the air line is shut-off and drained of air before removi

8 TroubleshootingProblem Possible Cause SolutionThe tool runs slowly or will not operate.There is grit or gum in the tool. Flush the tool with air to

9 HUSKYTOOLS.COM Please contact 1-888-43-HUSKY for further assistance.Service Parts

Più documenti per no Husky H4470

Nessun commento